ice maker inlet valve. Empty the glass as it fills. Water supply tubing made of " plastic is not recommended since it greatly increases the potential for water leaks. Slide the brass compression nut that comes with a copper supply line installation kit over the water supply line. With steel clamp and screw, secure water supply line to rear panel of refrigerator as shown.
Dvr hookup, Best hookup sites reddit,
Do not over tighten the connection. Locate the water inlet valve on the back of the refrigerator. Slide the refrigerator into position. If you have a water dispenser on your fridge, dispense about a gallon of water and spill it down the kitchen sink drain. Saddle valve for refrigerator water line. How to install a water line to your fridge so you can use your fridges ice maker and water dispenser If you know of an easier way to install a water line for a refrigerator ice maker and water dispenser, please leave a comment below. Slip the ferrule into the valve inlet and use your fingers to tighten the compression nut. Make sure NOT to drill too far and make another hole out the other side of the pipe. DO NOT install water supply tubing in areas where temperatures fall below freezing. Before Installing The Water Supply Line, You Will Need. Chemicals from a malfunctioning softener can damage the ice maker. Push water supply line into water valve inlet as far as it will go ( inch).